Posts Tagged ‘North Oaks’

Andover Plumbing Q/A: Why Do I Need Water Filtration?

Monday, June 25th, 2012

Like most Andover homeowners, you’re probably asking yourself why you need water filtration – what exactly happens to your water that makes it necessary to install an entire new system in your home to keep it clean? There are a few things that might be an issue here and your specific circumstances will determine which affects you the most.

 Common Water Contaminants

While most homes don’t suffer from all of the following, there is a good chance you will have at least some of these contaminants in your home:

  • Sediment
  • Bacteria
  • Chlorine
  • Copper
  • Fluoride
  • Iron
  • Manganese
  • Nitrate
  • Sulfate
  • Viruses

This is only a partial list too – there are a number of other, more exotic substances that might be in your water. Now, this doesn’t mean your water suffers from all or even most of these problems. Many homes only have one or two contaminants and they may not even be immediately dangerous to your health.

But, here’s the issue – and the number one reason that most homes in Andover should have a water filtration system. Things change. While your home may not suffer from virus or sulfate infiltration now, it could later. Things happen to the water supply – pipes get old, things get into the water tables and chemical levels change at treatment plants.

The only way to combat these problems is to have a good water filtration system already in place. Specifically, a reverse osmosis system that can remove all of these contaminants through an advanced chemical process.

 Testing Comes First

To make sure you have the right system in place to tackle your water contamination problems, make sure you first contact someone to perform full water testing on your home’s drinking water. Because some of these contaminants must be treated with chemical infusions through pumps or special cartridges, it is important to know in advance what you’re up against. Call Air Mechanical Heating, Cooling & Plumbing today if you think you need water filtration in your home!

Tags: , , , ,
Posted in Services | Comments Off

Rosemount HVAC Tip: Save Money in the Long Haul with AC Maintenance

Monday, June 18th, 2012

Every year, it’s recommended that you have a Rosemount HVAC contractor visit your home and tune up your air conditioner. This visit will ensure the system is ready for the intense, regular use it will receive during the hottest months of the year. How much money can this visit save you, though? Let’s take a closer look.

Cost of Operating Your Air Conditioning

An air conditioning system on average costs a homeowner between $500 and $1500 per year to operate depending on the length of the cooling season and the efficiency of that air conditioner. That number represents top efficiency for the unit, however. When a system has dirty filters, hasn’t been cleaned properly or the thermostat is no longer calibrated accurately, the cost increases – sometimes dramatically.

Just how much more could you be spending on cooling each month when this happens? The EPA’s Energy Star website estimates an increase in cost of between 10-30% resulting from poorly maintained systems, and it can be even higher if your system is old and is severely affected by a drop in energy efficiency.

Annual Tune Up Necessities

So, what should be at the top of your tune up list? If you call a Rosemount HVAC contractor, they will perform a variety of tasks including:

  • Inspect Coolant and Pressure Systems
  • Calibrate the Thermostat
  • Tighten Wiring, Capacitors, Relays and Contacts
  • Clean the Evaporator Coil
  • Clear and Clean the Condenser and Condensate Drain
  • Inspect the Condenser Fan and Motor
  • Check Compressor Efficiency

This is just a starter list for standard tune up of a central air conditioning unit. You can supplement this tune up by checking your filters once every 30 days and clearing away debris from around any outdoor units. You should also check your thermostat monthly to ensure it is working properly. If not, call for an inspection to avoid heavy increases in operating costs.

Major repairs to your air conditioning system generally take less than a day and when you’re on an annual maintenance plan, they cost significantly less than if you needed someone to fix the device in an emergency situation. To schedule an appointment today, give Air Mechanical Heating, Cooling & Plumbing a call!

Tags: , , , ,
Posted in Services | Comments Off

Sump Pump Maintenance for Eden Prairie Homes

Wednesday, February 22nd, 2012

A good sump pump is the only thing standing between you and a basement full of water, so it makes sense to implement a good maintenance plan for your Eden Prairie Home. A lot of homeowners don’t even think about their sump pumps, however, probably because they are buried out of sight, but the only way to know for sure that it will work when you need it most is to keep it in good operating condition. Here are some tips to help you do just that:

  • Check the GFCI – Your sump pump should be plugged into a Ground Fault Circuit Interrupter (GFCI). This is a special outlet that keeps the system from getting waterlogged. If it gets damp, it shuts down, turning off your sump pump. Unfortunately, GFCIs can be faulty or break, so check it regularly to make sure it is always on.
  • Upright Operation – If you have a standing sump pump, make sure it stays upright and doesn’t fall over when operating. These things can move a lot and if they do fall over, they may not pump properly.
  • Test it Regularly – Pour water into the sump pit when empty to make sure it will work when needed. Most people who need emergency service could have pinpointed the problem weeks or months earlier if they had known the system was broken.
  • Check the Outlet Pipes – Check the outlet pipes regularly for leaks or damage. If they start leaking back into the foundation, they can cause damage or leakage into the basement.
  • Clean the Grate – Submersible pumps are often left to sit in their pits for months or even years without cleaning. At least once a year, remove the sump pump from its pit and clean away any gunk that’s built up. Stones or debris in the pump can break the motor if left unchecked.

A good sump pump is all that stands between your home and a boat load of water whenever it rains. To keep your home clean and dry, check your pump often and if necessary, call someone for routine plumbing maintenance.

Most of the problems that pop up with sump pumps can be avoided entirely if they are maintained on an annual basis. Sometimes you may need to call Air Mechanical for advanced cleaning or part replacement. If so, try and do so before the raining season starts.

Tags: , ,
Posted in Services | Comments Off

How Often Should I Have My North Oaks Geothermal System Checked?

Monday, January 2nd, 2012

The beauty of a geothermal system for your North Oaks home is that is requires very little maintenance. They have fewer mechanical components are than other heating systems – and most of these components are underground or inside, shielded from the outdoor elements. The underground tubing usually is guaranteed to last 25-50 years and inside components are easily accessible for servicing.

Nonetheless, keeping a geothermal system working at peak efficiency is very important. If the geothermal system loses some of its efficiency, it will cost home and building owners money in energy costs, which makes little sense since geothermal system installation costs are higher than most other heating systems.

Its key component is the ground loop system, polyethelene tubing which carries refrigerant from below the Earth’s surface and back to an above-ground compressor. When installed correctly, the buried ground loop can last for decades. A leak in the metal tubing is usually the only problem if the ground loop is not installed correctly. In the case of a leak, it may be necessary to dig up the tubing – often installed at least ten feet below the surface – and repair the leak.

Other geothermal system components include its air handling unit, compressor, and pump. These components require periodic system checks by qualified heating and cooling technicians. Maintenance normally requires filter changes and component lubrication, to name the most common. In some cases, building owners can perform their own filter replacement and refill of lubricants. However, it is recommended that an experienced technician perform a multiple-point inspection of the geothermal system components, usually during regularly scheduled annual or bi-annual service calls.

Tags: , , , , ,
Posted in Services | Comments Off